Climbing (Bouldering/Traverse Climbing Wall)
Secondary - Intramural 2025
-
Portable Installation on School Site, Permanent Installation on School Site, Permanent Installation on Commercial Site
-
Bouldering Walls: Students combine vertical and horizontal movement on relatively low, artificial climbing walls, un-roped, protected by thick matting, which may include large overhangs and caves. In situations where the falling climber may injure a spotter (for example, the wall angle is steep and/or the climber is high), a spotter must not be used.
-
Traverse Walls: Students move mainly horizontally rather than vertically on relatively low, mainly flat, artificial climbing walls, un-roped, protected by matting, and may be assisted by spotters.
-
Outdoor bouldering on natural rock is not permissible.
- Also consult Climbing (General Procedures).
Equipment
- All equipment must be inspected by qualified personnel prior to activity.
Mats
-
Bouldering Mats: A mat surface (solid or cross-linked foam or equivalent) must be in place under the bouldering area. The mats must extend a minimum of 6 feet (approx.1.83 m.) from the outward most point from the wall (minimum mat thickness is 6”). Where the height increases and/or angle of the wall (for example, overhangs or caves) increases, the thickness of matting must also increase accordingly (for example, 12”-24”).
-
Traverse Wall Mats: A mat surface (solid or cross-linked foam or equivalent) or an impact attenuating surface as per the manufacturer recommendations must be in place under the traverse area.
-
Mat thicknesses:
-
cross-link foam 5cm (2’’)
-
open-cell foam 5cm (2”)
-
polyurethane 5cm (2”)
-
dual-density 5cm (2”)
-
mats of equivalent compaction rating as determined by manufacturer
-
Clothing/Footwear/Jewellery
-
Clothing and footwear appropriate to the activities and environmental conditions must be worn.
-
Exposed jewellery is not permitted.
-
Medic alert identification and religious articles of faith that cannot be removed must be taped or securely covered.
Facilities
-
Students must be encouraged to report facility problems to the Teacher.
-
Area for climbing must be appropriate for ability levels, age and size of students.
-
All providers must follow the Ontario Building Code Act, and all applicable By-Laws and Regulations.
-
All climbing walls must be installed by qualified personnel (for example, Qualified Instructor/Outside Activity Provider).
-
The initial installation of a bouldering or traverse wall must be inspected by qualified personnel upon completion of the installation and at least once a year thereafter by qualified inspection personnel.
-
This inspection must be documented with a written report. Necessary changes noted in the report must be addressed.
Environmental Considerations
Special Rules/Instructions
-
Completed medical forms for each participating student must be accessible.
-
Prior to the first lesson, Teachers must inform Qualified Climbing Instructors of students who have special needs.
-
Risks involved with each activity and how to lower the risk of an injury from occurring must be communicated to students.
-
Activity and course elements that are introduced must be based on skills that are taught and appropriate for the age, ability level, language and and experience of the students.
-
An introductory lesson must be an integral part of the program for all students.
-
Students must be allowed to select a challenge at their comfort level, including the choice to not participate.
-
Teachers and Monitors must be aware of the possibility of peer pressure and make sure no student is coerced into participating.
-
Qualified Instructors must ensure that the landing zone under climbers is free of people and objects.
-
A trained adult and/or student must be instructed in the safe and correct way of moving and handling the Bouldering/Traverse Climbing Wall (e.g., lifting, setting up/taking down/adjusting).
-
When dismounting the wall, students must attempt to climb down from the wall rather than jumping or falling.
-
The hands of the student must not be more than 3.5m (11’6”) above the landing surface.
-
In order to minimize the risk of injury to both climbers and spotters, the activity provider must consider use of down-climb holds; instruction on proper falling technique and conscientious route planning; and seamless floor padding.
-
Students who have been trained and can demonstrate the required instructor skills, and who are 16 years of age or older, can assist with instruction but must be directly supervised by a Qualified Instructor.
Traverse Wall Spotting
-
Prior to the activity, the Qualified Instructor must determine whether a spotter is to be used.
-
During initial instruction, a spotter may be used. The spotter’s role is that of breaking or interrupting the fall of a climber, moving with the climber as they progress; it is not to fully absorb the fall of a climber. A student may fulfill the role of the spotter, provided instruction has been given.
Bouldering Spotting
-
Prior to the activity, the Qualified Instructor must determine whether a spotter is to be used.
-
Prior to the use of spotters, instruction must be provided to spotters on proper technique.
-
In bouldering situations where a falling climber may injure a spotter (for example, the wall angle is steep (for example, the climber is in a non-vertical position) and/or the climber is high (for example, climber’s feet are more than 90cm/3 feet off the ground), a spotter must not be used.
-
Students must not walk under anyone bouldering.
Supervision
-
Direct Supervision is required when trained students are moving and handling equipment (e.g., lifting, setting up/taking down/adjusting).
-
On-Site Supervision is required for the duration of all other components of the activity (e.g., warm-ups/cool downs, application of the skills, games).
-
A Teacher must be present for all aspects of the program.
Supervision/Monitoring Ratios
-
Bouldering: 1 Qualified Instructor per 16 students.
-
Traverse Walls: 1 Qualified Instructor per 16 students (not including spotters).
Qualifications
Outside Provider Instructor Qualifications
-
Qualified Instructors must be trained in, understand, demonstrate, and adhere to a directly relevant skill set for bouldering/traverse climbing. A relevant skill set is a described set of skills developed by recognized climbing professionals.
-
All Qualified Instructors must be at least 18 years of age or older to teach the introductory lesson and/or be a Qualified Instructor.
-
After initial instruction, an individual (for example, Teacher who is trained in the skills and safety elements of bouldering/traverse climbing) can monitor students who are bouldering/traverse climbing.
Qualifications Applicable to Permanent Traverse Walls
- Teachers must have attended and successfully completed training on the safe use of the elements of the school site’s traverse wall by a climbing professional (for example, climbing companies).
First Aid
Definitions
Wed, 08/20/25 11:57 am